LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 213 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC 52/B0108: Short To Battery In Passenger-Side Air Bag Module Squib Circuit >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Toyota Tundra. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Access and check passenger-side air bag cut-off switch function. See PASSENGER-SIDE AIR BAG CUT-OFF SWITCH  under COMPONENT TESTING. If switch is okay, go to next step. If switch fails any part of test, replace switch.
  3. Connect negative battery cable. Wait 2 seconds. Turn ignition switch to ON position. Measure voltage between ground and Yellow/Red wire (circuit P+) on passenger-side air bag cut-off switch side of passenger-side air bag module harness connector. See WIRING DIAGRAMS . If voltage is zero volt, go to next step. If voltage is not zero volt, go to step  6.
  4. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect air bag sensor assembly connector C5 (center connector) to air bag sensor assembly. Connect jumper wire between Yellow/Red wire (circuit P+) and Yellow/Green wire (circuit P-) on passenger-side air bag cut-off switch side of passenger-side air bag module harness connector. Ensure passenger-side air bag cut-off switch is in ON position. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 52/B0108 is not displayed, go to next step. If DTC 52/B0108 is displayed, replace air bag sensor assembly.
  5. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect passenger-side air bag module connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ON position. Wait at least 20 seconds. Retrieve DTCs. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 52/B0108 is not displayed, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT . If DTC 52/B0108 is displayed, replace passenger-side air bag module.
  6. Disconnect connector between air bag sensor assembly and passenger-side air bag cut-off switch. Measure voltage between ground and Yellow/Red wire (circuit P+) on air bag sensor assembly side of passenger-side air bag cut-off switch harness connector. If voltage is zero volt, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT . If voltage is more than zero volt, repair or replace harness or connector between passenger-side air bag cut-off switch and air bag sensor assembly.
scientia non olet · About LEMON Manuals