LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 211 (Air Bag Restraint Systems) >> Diagnostic Tests >> DTC 11/B0102: Driver-Side Air Bag Squib Circuit Short To Ground >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disable air bag system. See DISABLING SYSTEM  under DISABLING & ACTIVATING AIR BAG SYSTEM.
  2. Measure resistance between ground and Yellow/Black wire on spiral cable side of upper spiral cable connector. See WIRING DIAGRAMS . If resistance is more than one megohm, go to next step. If resistance is less than one megohm, go to step  5.
  3. Reconnect air bag sensor assembly connector A24 (center connector). Connect jumper wire between Yellow/Black wire and Yellow wire on spiral cable side of upper spiral cable connector. Connect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear DTCs. See CLEARING CODES  under DIAGNOSTICS. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Retrieve codes. See RETRIEVING CODES  under DIAGNOSTICS. If DTC 11/B0102 is retrieved, replace air bag sensor assembly. If DTC 11/B0102 is not retrieved, go to next step.
  4. Turn ignition switch to LOCK position. Disconnect negative battery cable. Wait at least 90 seconds. Reconnect upper spiral cable connector (to driver-side air bag module). Reconnect negative battery cable. Wait at least 2 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Clear DTCs. Turn ignition switch to LOCK position. Wait at least 20 seconds. Turn ignition switch to ACC or ON position. Wait at least 20 seconds. Retrieve codes. If DTC 11/B0102 is retrieved, replace driver-side air bag module. If DTC 11/B0102 is not retrieved, system is functioning properly at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT .
  5. Disconnect lower spiral cable connector. Measure resistance between ground and Yellow/Black wire on spiral cable side of upper spiral cable connector. If resistance is more than one megohm, go to next step. If resistance is less than one megohm, replace spiral cable.
  6. Measure resistance between ground and Yellow/Black wire on air bag sensor assembly side of lower spiral cable connector. If resistance is more than one megohm, system operation is normal at this time. Check for intermittent fault. See AIR BAG WARNING LIGHT INTERMITTENT . If resistance is less than one megohm, replace wiring harness between spiral cable and air bag sensor assembly.
scientia non olet · About LEMON Manuals