Crankshaft Rear Oil Seal: Installation
WARNING: This page is about a different car, the 2002 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
- Ensure all sealing surfaces are clean. Apply grease to lip of NEW crankshaft rear oil seal. Using a hammer and Oil Seal Installer (09223-56010), install NEW rear crankshaft oil seal in housing until seal is even with housing surface.
- Apply Three Bond 1234 to threads of drive plate bolts. Install drive plate with front and rear spacers on crankshaft and tighten bolts to specification in 2 steps. See Fig 1. See TORQUE SPECIFICATIONS . Install transmission to engine. Apply Three Bond 1234 to threads of torque converter bolts and install the Black colored bolt first. Install flywheel access cover. To install remaining components, reverse removal procedure.