LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 209 (Engine Mechanical) >> Removal & Installation >> Crankshaft Front Seal >> Removal & Installation (Oil Pump Installed)

Removal & Installation (Oil Pump Installed)

WARNING: This page is about a different car, the 2002 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove timing belt and crankshaft sprocket. See TIMING BELT REPLACEMENT - 4.3L article. Using a knife, cut seal lip from crankshaft front seal. Carefully pry crankshaft front seal from oil pump body. DO NOT damage sealing surfaces.
  2. To install, apply grease to sealing lip of crankshaft front seal. Using a hammer and Seal Installer (SST 09316-60011), install NEW crankshaft front oil seal until seal surface is even with oil pump body. To install remaining components, reverse removal procedure.
scientia non olet · About LEMON Manuals