EVAP Leak Test
WARNING: This page is about a different car, the 2003 Lexus GX 470. However, it is still accessible from the selected car via links, so may be relevant.
- Connect hand-held tester to DLC3. See Figure.
- Select "ENHANCED OBD II/SYSTEM CHECK/EVAP SYS CHECK (or EVAP LEAK TEST)" mode on hand-held tester.
- If no changes occur within one minute after pressing "EVAP LEAK TEST", remove fuel tank cap and install it. Then perform "EVAP SYS CHECK (or EVAP LEAK TEST)". Display in hand-held tester will display whether a leak has been detected.
- If a leak is detected, or if DTCs P0441, P0442, and P0446 are output simultaneously, conduct a leak test again after repair. If no leak is found by second test, EVAP system is repaired.