LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 184 (Hydraulic Brake Booster) >> Bleeding Brake System >> Hydraulic Brake Booster >> With Hand-Held Tester (Prius)

With Hand-Held Tester (Prius)

WARNING: This page is about a different car, the 2002 Toyota Prius, 2002 Toyota Land Cruiser, 2002 Toyota 4Runner, 2001 Toyota Prius, and 2001 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
    NOTE: Do not keep solenoid activated for more than 2 seconds at one time. Allow an interval of 20 seconds or more if activating solenoids continuously.
  1. Turn ignition OFF and connect hand held tester to DLC3, located under driver's side knee panel. Turn ignition switch ON, and select AIR BLEEDING on hand held tester. While holding down brake pedal, turn SRRR solenoid ON with hand held tester.
  2. Turn SRRR solenoid OFF with the hand tester, and release brake pedal. Check that the pump motor stops after 20 seconds. Repeat step  1 three times.
  3. Turn ignition OFF and disconnect hand tester. Clear DTC. See 2001-02 BRAKES - PRIUS article. After erasing, turn ignition OFF to protect ECU.
  4. With ignition OFF, depress the brake pedal more than 40 times. Remove reservoir cap and add brake fluid to MAX line.
scientia non olet · About LEMON Manuals