LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Electronic Suspension) >> Trouble Shooting >> System Pre-Check >> Damping Force Controlling Condition

Damping Force Controlling Condition

WARNING: This page is about a different car, the 2003 Lexus LS 430, 2002 Lexus LS 430, and 2001 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Using special tool (09843-18040), jumper between terminals Ts and CG of the (DLC3). See Figure. The absorber control indicator light flashes once per second. If absorber control indicator light does not flash, check the Ts terminal. See TEST E: Ts TERMINAL CIRCUIT  under SYSTEM TESTS.
  2. Turn the ignition switch to ON. Check that damping force changes from soft to hard when the absorber control switch is turned on and off by pushing up and down on each corner of the vehicle.
  3. Turn the ignition switch off and remove the special tool from the (DLC3).
scientia non olet · About LEMON Manuals