LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Electronic Suspension) >> Removal & Installation >> Height Control Sensor & Acceleration Sensor (Front) >> Installation

Height Control Sensor & Acceleration Sensor (Front): Installation

WARNING: This page is about a different car, the 2003 Lexus LS 430, 2002 Lexus LS 430, and 2001 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Align matchmarks on height control sensor link and bracket.
  2. Install nut, connect sensor link and tighten to specification. See TORQUE SPECIFICATIONS .
  3. Install front height control sensor and acceleration sensor with 2 bolts and tighten to specification. See TORQUE SPECIFICATIONS .
  4. Connect harness connector.
  5. Install front left fender liner and wheel. Tighten lug nuts to specification. See TORQUE SPECIFICATIONS .
  6. Check vehicle height. See VEHICLE HEIGHT  under ADJUSTMENTS.
scientia non olet · About LEMON Manuals