LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 180 (Electronic Suspension) >> Removal & Installation >> Height Control Compressor & Dryer >> Installation

Height Control Compressor & Dryer: Installation

WARNING: This page is about a different car, the 2003 Lexus LS 430, 2002 Lexus LS 430, and 2001 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. To install, reverse removal procedure. If replacing O-ring coat it with MP grease. Slowly push in dryer along the dryer axis. Install bolt and tighten to specification. See TORQUE SPECIFICATIONS .
  2. Install 2 bolts, bushing and bracket to height control compressor and tighten to specification. See TORQUE SPECIFICATIONS .
  3. Install 4 bolts and height control compressor with bracket and tighten to specification. See TORQUE SPECIFICATIONS .
  4. Coat 2 new O-rings with MP grease. Push air tube straight in until clip makes a "click" sound.
  5. Check for leaks. See CONNECTIONS OF TUBES & HOSES FOR AIR LEAKAGE  under COMPONENT TESTS.
  6. Install fender liner and front wheel and tighten lug nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals