Circuit Description

Air/Fuel (A/F) sensor monitors exhaust gas oxygen content and delivers an input signal to ECM. ECM uses input signal to control air/fuel ratio. A/F sensor includes a heater. DTC P1133 applies to bank No. 1 sensor No. 1 and DTC P1153 applies to bank No. 2 sensor No. 1. Heated A/F sensors are located on exhaust manifold above catalytic converters. A/F sensor for cylinders No. 1 and 4 is referred to as bank No. 1 sensor No. 1. A/F sensor for cylinders No. 2 and 3 is referred to as bank No. 2 sensor No. 1. A/F sensors may also be referred to as A/F ratio sensors. DTC is set when A/F sensor output does not change with engine speed at 1400 RPM or more with vehicle speed at more than 38 MPH. Possible cause is:

• A/F sensor circuit is open or shorted.
• Defective A/F sensor.
• Air induction system malfunction.
• Improper fuel pressure.
• Defective fuel injector.
• Defective ECM.