LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 163 (Moon Roof) >> Circuit Tests >> Moon Roof Gear Assembly With Ecu Circuit >> Diagnostic Procedure

Diagnostic Procedure

WARNING: This page is about a different car, the 2003 Lexus RX 300 and 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If not using the hand-held tester, begin with step  2.
    CAUTION: Caution is necessary not to be caught in as the jam protection system does not operate during conducting ACTIVE TEST.
    NOTE: With one ACTIVE direction, the moon roof can slide and tilt continuously.
  1. Connect the hand-held tester to the DLC3. See Figure. Enter into ACTIVE TEST function of hand-held tester. Check that Moon Roof Motor operates as the hand-held tester directs. If the motor operates normally, go to MOON ROOF CONTROL SWITCH CIRCUIT . If the motor does not operate normally, replace the moon roof drive gear assembly. See MOON ROOF  under REMOVAL & INSTALLATION.
  2. Replace the moon roof drive gear assembly. See MOON ROOF  under REMOVAL & INSTALLATION.