LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 15 (Engine Controls - Basic Diagnostic Procedures - 4-Cylinder) >> Ignition Systems >> Crankshaft Position Sensor >> MR2

Crankshaft Position Sensor: MR2

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove lower front engine cover. Remove A/C compressor for access to crankshaft position sensor. It may be necessary to discharge A/C system for removal of A/C compressor. Crankshaft position sensor is located on front of timing chain cover, near crankshaft pulley. See Figure.
  2. Disconnect crankshaft position sensor electrical connector. Using ohmmeter, check resistance between electrical terminals on crankshaft position sensor electrical connector. Ensure crankshaft position sensor resistance is within specification. See CRANKSHAFT POSITION SENSOR RESISTANCE  table. Replace crankshaft position sensor if resistance is not within specification. See CRANKSHAFT POSITION SENSOR under IGNITION SYSTEMS in REMOVAL, OVERHAUL & INSTALLATION - 4-CYLINDER article. Reinstall crankshaft position sensor electrical connector and A/C compressor. Tighten A/C compressor retaining bolts to 18 ft. lbs. (24 N.m). Install lower front engine cover.
scientia non olet · About LEMON Manuals