Torque Specifications: Sequoia
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS (SEQUOIA)
| Application | Ft. Lbs. (N.m) | ||
|---|---|---|---|
| Control Shaft Lever Nut | 10 (13) | ||
| ECT Sensor | 15 (20) | ||
| Front Fuel Pipe-To-Fuel Rail Union Bolt | 29 (39) | ||
| Fuel Pulsation Damper | 29 (39) | ||
| Fuel Rail-To-Intake Manifold Nut | 13 (18) | ||
| Fuel Tank Strap Bolt | 45 (61) | ||
| Heated Oxygen Sensor-To-Exhaust Manifold | 32 (43) | ||
| Heated Oxygen Sensor-To-Exhaust Pipe Retaining Nut | 15 (20) | ||
| Intake Manifold Bolt/Nut | 15 (20) | ||
| Knock Sensor | 33 (45) | ||
| Oil Cooler Line-To-Transmission Nut | 25 (34) | ||
| PNP Switch Retaining Bolt | 10 (13) | ||
| Throttle Body Bolt/Nut | 13 (18) | ||
| Vehicle Speed Sensor No. 1 Retaining Bolt | 12 (16) | ||
| Vehicle Speed Sensor No. 2 Retaining Bolt | (1) | ||
| INCH Lbs. (N.m) | |||
| Accelerator Pedal Position Sensor Retaining Screw | 44 (5) | ||
| Camshaft Position Sensor Bolt & Stud Bolt | 62 (7) | ||
| Control Cable Insulator Bolt | 44 (5) | ||
| Crankshaft Position Sensor Bolt | 62 (7) | ||
| Driver's Side Upper Timing Belt Cover Bolt/Nut | 62 (7) | ||
| Front Fuel Pipe Clamp Bolt | 62 (7) | ||
| Fuel Pressure Regulator Bolt | 62 (7) | ||
| Fuel Pump Mounting Bracket-To-Fuel Tank Bolt | 35 (4) | ||
| Fuel Pump Resistor Bolt | 71 (8) | ||
| Fuel Return Pipe-To-Fuel Rail Clamp Bolt | 62 (7) | ||
| Ignition Coil Bolt | 62 (7) | ||
| PNP Switch Retaining Nut | 35 (4) | ||
|
|||