LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Engine Controls - Removal & Installation - V6 & V8) >> Torque Specifications >> CAMRY SOLARA

CAMRY SOLARA

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATIONS (CAMRY SOLARA)

Application Ft. Lbs. (N.m)
A/F Sensor 32 (43)
Air Intake Chamber Bolt/Nut 32 (43)
Air Intake Chamber Support Brace Bolt 15 (20)
Control Cable Nut 11 (15)
Control Lever Nut
A541E 11 (15)
U241E 10 (13)
Coolant Housing Bolt/Nut 11 (15)
ECT Sensor 15 (20)
EGR Gas Temperature Sensor 15 (20)
Engine Hanger Bolt 29 (39)
Engine Mount Support Brace Bolt 23 (31)
Fuel Line-To-Intake Manifold Clamp Bolt 15 (20)
Heated Oxygen Sensor 32 (43)
Intake Air Control Valve Nut 11 (15)
Intake Manifold Bolt/Nut (1) 11 (15)
Knock Sensor 29 (39)
Power Steering Pressure Switch 15 (20)
Suspension Upper Brace Nut 59 (80)
Throttle Body Bolt/Nut 15 (20)
INCH Lbs. (N.m) 
Camshaft Position Sensor Bolt 71 (8)
Crankshaft Position Sensor Bolt 71 (8)
EGR Pipe Nut 106 (12)
EGR Position Sensor-To-EGR Valve Nut 18 (2)
EGR Valve Retaining Nut 106 (12)
Fuel Pressure Regulator Retaining Screw 18 (2)
Fuel Pump Protector Cover Bolt 35 (4)
Fuel Pump Retaining Plate-To-Fuel Tank Bolt 35 (4)
Fuel Rail-To-Intake Manifold Bolt 89 (10)
Ignition Coil Bolt 71 (8)
PNP Switch Retaining Bolt 44 (5)
PNP Switch Retaining Nut 62 (7)
Round Fuel Filter Retaining Screw 18 (2)
Vehicle Speed Sensor Retaining Bolt
A/T (2)
M/T 53 (6)
(1) Tighten bolts/nuts to specification in sequence. See Figure.
(2) On models equipped with A541E transaxle, tighten bolt to 44 INCH lbs. (5 N.m). On models equipped with U241E transaxle, tighten bolt to 53 INCH lbs. (6 N.m).