Removal & Installation (Sienna)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Remove "V" bank cover if necessary to access ignition coils mounted on top of valve covers. See Figure.
- Disconnect electrical connector at ignition coil. Remove bolt and ignition coil.
- To install, reverse removal procedure. Tighten bolt for ignition coil and windshield wiper arm nut (if removed) to specification. See TORQUE SPECIFICATIONS .