Removal & Installation (4Runner 4.0L)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Remove "V" bank cover.
- Remove air cleaner hose assembly.
- Disconnect electrical connector at ignition coil mounted on top of valve cover.
- Remove bolt and ignition coil.
- To install, reverse removal procedure. Tighten bolt for ignition coil to specification. See TORQUE SPECIFICATIONS .