Removal & Installation (Land Cruiser, Sequoia, Tundra 4.7L & 4Runner 4.7L)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft position sensor is located at front of crankshaft, near crankshaft pulley. See Fig 1.
- Remove lower engine cover for access to crankshaft position sensor.
- Disconnect electrical connector at crankshaft position sensor. Remove bolt and crankshaft position sensor.
- To install, reverse removal procedure. Tighten bolt to specification. See TORQUE SPECIFICATIONS .