Disassembly & Reassembly (Jan. 2003 & Later Production)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Using screwdriver, release snap fit areas on No. 2 fuel suction support and remove No. 2 fuel suction support from bottom of fuel pump. Remove rubber cushion from bottom of fuel pump. See Figure.
- Disconnect fuel sending gage electrical connector. Using screwdriver, disengage clamp to release fuel sending gage. Slide fuel sending gage downward to remove.
- Disconnect fuel pump electrical connector. Using screwdriver, release snap fit areas on fuel suction plate subassembly and separate fuel suction plate subassembly from fuel filter assembly. See Figure.
- Disconnect fuel pump harness electrical connector on fuel filter. Using screwdriver, pry out fuel pump harness.
- Remove fuel pump with fuel filter from fuel filter assembly.
- Using small screwdriver, remove retaining clip that holds fuel filter on bottom of fuel pump. Remove fuel filter from bottom of fuel pump.
- Remove fuel pressure regulator with "O" ring. See Figure.
- To reassemble, reverse disassembly procedure using NEW retaining clip on fuel filter and NEW "O" ring. Coat "O" ring with gasoline before installing. Ensure fuel gauge sending unit is fully locked in place by pushing fuel gauge sending unit downward.