Removal & Installation (Camry Solara)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Remove air cleaner assembly for access to vehicle speed sensor.
- Vehicle speed sensor is located on transaxle. See Fig 1. Disconnect electrical connector at vehicle speed sensor.
- Remove retaining bolt and vehicle speed sensor with "O" ring from transaxle. If necessary to remove drive gear assembly from vehicle speed sensor, remove retaining clip from outside of vehicle speed sensor. Retaining clip is located just below "O" ring groove on vehicle speed sensor. Remove drive gear from vehicle speed sensor.
- To install, reverse removal procedure using NEW "O" ring. Coat "O" ring with Dexron-III ATF (A/T models) or gear oil (M/T models) before installing on vehicle speed sensor. Tighten retaining bolt to specification. See TORQUE SPECIFICATIONS .