Removal & Installation (Avalon, Camry Solara, Highlander, Land Cruiser, Sequoia, Sienna, Tundra & 4Runner)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Remove necessary components for access to brakelight switch. Brakelight switch is located near top of brake pedal.
- Disconnect electrical connector at brakelight switch. Loosen lock nut on brakelight switch. Remove brakelight switch from mounting bracket.
- Depress brake pedal.20-.59" (5.0-15.0 mm) and hold brake pedal in this position to install brakelight switch in mounting bracket. Install electrical connector on brakelight switch.
- Rotate brakelight switch until brakelights go off. Tighten lock nut on brakelight switch. Release brake pedal.
- Depress brake pedal.20-.59" (5.0-15.0 mm) and ensure brakelights come on. Release brake pedal. Ensure brakelights go off.