Removal & Installation (Land Cruiser, Sequoia, Tacoma, Tundra & 4Runner)
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
EVAP VSV servicing procedure is just primarily an unbolt and bolt-on procedure. See EVAP VSV LOCATIONS table. For illustration of EVAP VSV location, see EMISSION SYSTEMS & SUB-SYSTEMS in SYSTEM & COMPONENT TESTING - V6 & V8 article.
EVAP VSV LOCATIONS
| Application | Location | |
|---|---|---|
| Land Cruiser | Under "V" Bank Cover, At Driver's Side Center Of Intake Manifold Below Intake Manifold Cover | |
| Sequoia | At Driver's Side Center Of Intake Manifold | |
| Tacoma | On Bracket Bolted To Inside Of Driver's Side Front Fender Panel | |
| Tundra | ||
| 3.4L | At Driver's Side Rear Corner Of Air Intake Chamber | |
| 4.7L | At Driver's Side Center Of Intake Manifold | |
| 4Runner | ||
| 4.0L | At Driver's Side Center Of Air Intake Chamber | |
| 4.7L | At Driver's Side Center Of Intake Manifold | |