LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 132 (Engine Controls - Removal & Installation - V6 & V8) >> Emission Systems & Sub-Systems >> EGR Vacuum Switching Valve >> Removal & Installation (Camry & Camry Solara)

Removal & Installation (Camry & Camry Solara)

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove "V" bank cover. See Figure and Figure .
  2. The EGR Vacuum Switching Valve (VSV) is the rear inside VSV on emission control valve set. See Figure and Figure .
  3. Disconnect electrical connectors and vacuum lines from vacuum switching valves on emission control valve set.
  4. Remove emission control valve set.
  5. Remove EGR VSV from emission control valve set.
  6. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals