Removal & Installation
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
Ensure ignition is off. Remove Engine Control Module (ECM). See ECM LOCATION table. To install, reverse removal procedure.
ECM LOCATION
| Model | (1) Location | ||
|---|---|---|---|
| Avalon | Behind Glove Box, Near Passenger's Side Kick Panel | ||
| Camry | Behind Glove Box | ||
| Camry Solara | Behind Glove Box | ||
| Highlander | Behind Glove Box | ||
| Land Cruiser | Above Glove Box, Near Passenger's Side Of Instrument Panel | ||
| Sequoia | Behind Glove Box & Heater Duct | ||
| Sienna | Passenger's Side Of Instrument Panel, Just Below Glove Box | ||
| Tacoma | Behind Glove Box | ||
| Tundra | Behind Glove Box & Heater Duct | ||
| 4Runner | Behind Glove Box | ||
|
|||