LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Ignition Systems >> Crankshaft Position Sensor >> Removal (Celica)

Removal (Celica)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Crankshaft position sensor is located on front of engine, near crankshaft pulley. See Figure.
  2. Manufacturer states throttle body and intake manifold must be removed for access to crankshaft position sensor.
  3. Remove throttle body. See THROTTLE BODY  under FUEL SYSTEMS.
  4. Remove coolant reservoir and air cleaner case.
  5. Disconnect necessary hoses for removal of intake manifold.
  6. On models equipped with 2ZZ-GE engine, remove bolts/nuts and intake manifold support from rear of intake manifold. On all models, remove bolts/nuts, intake manifold and gasket from cylinder head.
  7. Disconnect electrical connector for crankshaft position sensor. Remove bolts and crankshaft position sensor.
scientia non olet · About LEMON Manuals