Removal & Installation (Tacoma)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft position sensor is located near crankshaft pulley, just above oil pan on driver's side of engine. See Fig 1.
- Raise and support vehicle.
- Remove lower engine cover.
- Disconnect negative battery cable.
- Disconnect electrical connectors at generator.
- Remove accessory drive belt, generator and generator mounting bracket.
- Disconnect electrical connector at crankshaft position sensor. Remove bolts and crankshaft position sensor with "O" ring.
- To install, reverse removal procedure using NEW "O" ring. Tighten bolts to specification. See TORQUE SPECIFICATIONS .