Removal & Installation (RAV4)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
- Crankshaft position sensor is located on front of engine, near crankshaft pulley. See Figure.
- Raise and support vehicle.
- Remove lower engine cover for access to crankshaft position sensor.
- Disconnect electrical connector for crankshaft position sensor.
- Remove bolt and crankshaft position sensor with "O" ring.
- To install, reverse removal procedure using NEW "O" ring. Tighten crankshaft position sensor bolt to specification. See TORQUE SPECIFICATIONS .