LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Ignition Systems >> Crankshaft Position Sensor >> Installation

Crankshaft Position Sensor: Installation

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install crankshaft position sensor. Install and tighten crankshaft position sensor bolts to specification. See TORQUE SPECIFICATIONS .
  2. To install remaining components, reverse removal procedure using NEW gaskets.
  3. On models equipped with 2ZZ-GE engine, note intake manifold bolt/nut identification before tightening intake manifold bolts/nuts to specification. See Figure. On all models, ensure gasket for throttle body is installed with protrusion area facing proper direction. See THROTTLE BODY  under FUEL SYSTEMS. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS .
  4. Fill and bleed cooling system. See COOLING SYSTEM BLEEDING  under COOLING SYSTEM.
Fig 1: Locating Crankshaft Position Sensor (Celica, Corolla, Matrix, MR2 & RAV4)
G98J01626Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002


  1. Install crankshaft position sensor. Install and tighten crankshaft position sensor bolts to specification. See TORQUE SPECIFICATIONS .
  2. To install remaining components, reverse removal procedure using NEW gaskets. Ensure gasket for throttle body is installed with protrusion area facing proper direction. See THROTTLE BODY  under FUEL SYSTEMS. Tighten bolts/nuts to specification. See TORQUE SPECIFICATIONS .
  3. Fill cooling system.
scientia non olet · About LEMON Manuals