Removal & Installation (Tacoma)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
- Camshaft position sensor is located on cylinder head, just in front of intake manifold. See Fig 1.
- Remove throttle body. See THROTTLE BODY under FUEL SYSTEMS.
- Disconnect electrical connector at camshaft position sensor. Remove bolt and camshaft position sensor from cylinder head.
- To install, reverse removal procedure. Tighten camshaft position sensor bolt to specification. See TORQUE SPECIFICATIONS .