Removal & Installation (Camry & Camry Solara)
WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
- Drain cooling system.
- Remove upper cap on air cleaner assembly with air cleaner hose.
- Disconnect coolant hose, vacuum hose and electrical connector at throttle body. Remove bolts, throttle body and gasket from intake manifold.
- Manufacturer does not provide information for servicing of throttle control motor and Throttle Position (TP) sensor.
- To install, reverse removal procedure using NEW gasket. Ensure gasket for throttle body is installed so protrusion (if equipped) aligns with groove on intake manifold. See Fig 1. Tighten throttle body bolts to specification. See TORQUE SPECIFICATIONS .
- Fill cooling system.