LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Fuel Systems >> Fuel Rails & Fuel Injectors >> Removal (MR2)

Removal (MR2)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE .
  2. Remove suspension upper brace and No. 2 cylinder head cover located on top of engine, above ignition coils and valve cover. See Figure.
  3. Remove PCV hose and engine wiring harness for access to fuel rail.
  4. Note location of electrical connectors on fuel injectors for installation reference. Disconnect electrical connectors at fuel injectors.
    CAUTION: When removing fuel rail, use care not to allow fuel injectors to fall from fuel rail.
  5. Remove fuel rail-to-cylinder head bolts. Remove fuel rail with fuel injectors as an assembly.
  6. Remove 2 spacers and 4 grommets from cylinder head.
  7. Remove fuel injectors from fuel rail. Remove "O" ring from fuel injector.
scientia non olet · About LEMON Manuals