LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Fuel Systems >> Fuel Pump >> Removal (Camry Solara)

Removal (Camry Solara)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE .
  2. Remove rear seat cushion and cover plate on floor panel for access to fuel pump if not previously done.
  3. Disconnect electrical connector from top of fuel pump. This is electrical connector for fuel pump and fuel gauge sending unit. Electric fuel pump is located in the fuel tank.
  4. Remove bolts and fuel pump protector cover located on fuel tank, above fuel pump. Ensure area around disconnect fitting on fuel line at fuel pump is clean. Depress both sides of retainer and pull fuel line with disconnect fitting from outlet tube on the fuel pump. See Fig 1.
  5. Remove fuel pump retaining plate-to-fuel tank bolts. Remove fuel pump retaining plate, fuel pump and gasket from fuel tank. Use care not to damage fuel filter on bottom of fuel pump and fuel gauge sending unit when removing fuel pump.
Fig 1: Disconnecting Fuel Line At Fuel Pump (Camry Solara)
G98F11929Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002