LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Engine Sensors & Switches >> Park/Neutral Position Switch >> Removal (Tacoma)

Removal (Tacoma)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. The Park/Neutral Position (PNP) switch is located on side of transmission. See Figure. Remove front exhaust pipe with heat insulator (if necessary) and disconnect transmission oil cooler line for access to PNP switch.
  2. Remove transmission oil cooler line elbow with "O" ring for access to PNP switch (if necessary). Disconnect electrical connector at PNP switch.
  3. Bend tabs upward on lock plate, away from PNP switch retaining nut. Remove PNP switch retaining nut, lock plate, PNP switch retaining bolt and PNP switch.
scientia non olet · About LEMON Manuals