LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Engine Sensors & Switches >> EGR Gas Temperature Sensor >> Removal & Installation (Tacoma 2.7L)

Removal & Installation (Tacoma 2.7L)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect electrical connector at EGR gas temperature sensor. EGR gas temperature sensor is located near EGR valve. See Fig 1.
  2. It may be necessary to remove EGR valve for access to EGR gas temperature sensor. See EGR VALVE  under EMISSION SYSTEMS & SUB-SYSTEMS.
  3. Remove EGR gas temperature sensor.
  4. To install, reverse removal procedure.
Fig 1: Locating EGR Gas Temperature Sensor (Tacoma 2.7L)
G99D08724Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002