LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Engine Sensors & Switches >> Airflow Meter >> Removal & Installation (Tacoma)

Removal & Installation (Tacoma)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition is off.
  2. Disconnect electrical connector at airflow meter. Airflow meter is located between air intake hose and upper cap on air cleaner assembly and is mounted on upper cap on air cleaner assembly.
  3. Disconnect necessary hoses for removal of upper cap on air cleaner assembly. Loosen clamp on air intake hose at airflow meter. Loosen retaining clips that retain upper cap on air cleaner assembly.
  4. Remove upper cap on air cleaner assembly with airflow meter from air cleaner assembly.
  5. Remove airflow meter retaining nuts, airflow meter and gasket from upper cap.
  6. To install, reverse removal procedure using NEW gasket. Tighten airflow meter retaining nuts to specification. See TORQUE SPECIFICATIONS .
scientia non olet · About LEMON Manuals