LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Emission Systems & Sub-Systems >> Vapor Pressure Sensor >> Removal & Installation (MR2)

Removal & Installation (MR2)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Vapor pressure sensor is located on top of fuel pump. See Figure.
  2. Apply tape to end of screwdriver to prevent scratching interior components. Using screwdriver, remove door opening scuff plates, lower trim covers and quarter trim covers. See Figure.
  3. Remove luggage compartment lids, luggage compartment boxes and cover plate on floor panel for access to vapor pressure sensor.
  4. Remove bolts and fuel pump protector cover located on fuel tank, above fuel pump.
  5. Disconnect electrical connector at vapor pressure sensor. Ensure area around vapor pressure sensor is clean. Remove retaining clip located just below the vapor pressure sensor. Remove vapor pressure sensor.
  6. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals