LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Emission Systems & Sub-Systems >> Vapor Pressure Sensor >> Removal & Installation (Camry)

Removal & Installation (Camry)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE .
  2. Remove rear seat cushion and cover plate on floor panel for access to fuel pump if not previously done.
  3. Disconnect vapor pressure sensor connector located on top of fuel pump. See Figure.
  4. Remove cover and disconnect clip to remove sensor.
  5. To install, reverse removal procedure.
scientia non olet · About LEMON Manuals