LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Emission Systems & Sub-Systems >> Canister Closed Valve Vacuum Switching Valve >> Removal (Prius)

Removal (Prius)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
WARNING: Read service precautions before proceeding with service procedure. See SERVICE PRECAUTIONS .
  1. Canister Closed Valve Vacuum Switching Valve (CCV VSV) is located on top of fuel tank. See Figure. Fuel tank must be removed for access to CCV VSV.
  2. Release fuel pressure. See FUEL SYSTEM PRESSURE RELEASE .
  3. Remove rear seat cushion and cover plate on floor panel for access to fuel pump if not previously done.
  4. Disconnect electrical connector from top of fuel pump. This is electrical connector for fuel pump and fuel gauge sending unit. Electric fuel pump is located in the fuel tank.
  5. Raise and support vehicle.
  6. Remove exhaust pipe assembly and tailpipe for access to fuel tank.
  7. Drain gasoline from fuel tank into approved container.
  8. Disconnect fuel filler tube and any remaining hoses for fuel tank removal.
  9. Support fuel tank with transmission jack. Remove fuel tank retaining bolts and fuel tank.
  10. Disconnect necessary hoses and electrical connectors for removal of CCV VSV and fresh air valve.
  11. Remove bolt and separate fresh air valve from CCV VSV. See Figure.
  12. Remove bolts for CCV VSV and remove CCV VSV along with trap filter and seal packing.
  13. Remove bolts and separate CCV VSV from trap filter.
scientia non olet · About LEMON Manuals