LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 131 (Engine Controls - Removal & Installation 4-Cylinder) >> Computerized Engine Controls >> Engine Control Module >> Removal & Installation (MR2)

Removal & Installation (MR2)

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Ensure ignition is off.
  2. Note location of Engine Control Module (ECM). See ECM LOCATION  table.
  3. Remove luggage compartment lids, luggage compartments, quarter trim panels, lower trim covers, partition board and cover for access to ECM. See Fig 1. For additional information on removal of luggage compartment components, see FUEL PUMP  under FUEL SYSTEMS.
  4. Remove ECM. To install, reverse removal procedure.
Fig 1: Locating Engine Control Module & Components (MR2)
G00011343Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002