A/T Models
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Disconnect electrical connector at Park/Neutral Position (PNP) switch. PNP switch is mounted on side of transmission/transaxle. Note terminal identification. See Fig 1-Fig 5 .
- Using ohmmeter, check for continuity between specified terminals with shift lever in proper positions. See PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS table. If proper continuity does not exist, adjust or replace PNP switch as necessary. For adjustment or replacement of PNP switch, see PARK/NEUTRAL POSITION SWITCH under ENGINE SENSORS & SWITCHES in REMOVAL & INSTALLATION - V6 & V8 article.
PARK/NEUTRAL POSITION SWITCH SPECIFICATIONS
| Application & Shift Lever Position | Continuity Between Terminals No. | |
|---|---|---|
| Avalon, Camry Solara & Sienna | ||
| Park | 2 & 7; 5 & 6 | |
| Reverse | 2 & 8 | |
| Neutral | 2 & 9; 5 & 6 | |
| Drive | 2 & 10 | |
| 2 | 2 & 3 | |
| Low | 2 & 4 | |
| Camry & Highlander | ||
| Park | 1 & 3; 6 & 9 | |
| Reverse | 2 & 3 | |
| Neutral | 3 & 5; 6 & 9 | |
| Drive | 3 & 7 | |
| 2 | 3 & 4 | |
| Low | 3 & 8 | |
| Land Cruiser & 4Runner 4.7L | ||
| Park | 1 & 3; 6 & 9 | |
| Reverse | 2 & 3 | |
| Neutral | 3 & 5; 6 & 9 | |
| Drive, 4 | 3 & 7 | |
| 3 | 3 & 4 | |
| 2, Low | 3 & 8 | |
| Sequoia | ||
| Park | 6 & 9 | |
| Reverse | 2 & 3 | |
| Neutral | 6 & 9 | |
| Drive | 3 & 7 | |
| 2 | 3 & 4 | |
| Low | 3 & 8 | |
| Tacoma & Tundra | ||
| Park | 6 & 9 | |
| Reverse | 3 & 6 | |
| Neutral | 6 & 9 | |
| Drive | 3 & 7 | |
| 2 | 3 & 4 | |
| Low | 3 & 8 | |
| 4Runner 4.0L | ||
| Park | 1 & 3; 6 & 9 | |
| Reverse | 2 & 3 | |
| Neutral | 3 & 5; 6 & 9 | |
| Drive, 3 | 3 & 7 | |
| 2 | 3 & 4 | |
| Low | 3 & 8 | |