Camry & Camry Solara
WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
NOTE:
Applies for Camry models produced up to January 2003.
- Remove EGR gas temperature sensor. EGR gas temperature sensor is screwed into bottom of pipe that EGR valve is mounted on. It may be necessary to remove throttle body for access to EGR gas temperature sensor. If necessary to remove throttle body for access to EGR gas temperature sensor, see THROTTLE BODY under FUEL SYSTEMS in REMOVAL & INSTALLATION - V6 & V8 article.
- Place threaded end of EGR gas temperature sensor and thermometer in container of oil. Attach ohmmeter between electrical terminals on EGR gas temperature sensor.
- Heat oil and note resistance at specified temperature. See EGR GAS TEMPERATURE SENSOR RESISTANCE table. Replace EGR gas temperature sensor if resistance is not within specification. Reinstall EGR gas temperature sensor.
EGR GAS TEMPERATURE SENSOR RESISTANCE
| Application & Temperature | Ohms | |
|---|---|---|
| Camry | ||
| 122°F (50°C) | 69,400-88,500 | |
| 212°F (100°C) | 11,890-14,370 | |
| 302°F (150°C) | 2790-3590 | |
| Camry Solara | ||
| 122°F (50°C) | 64,000-97,000 | |
| 212°F (100°C) | 11,000-16,000 | |
| 302°F (150°C) | 2000-4000 | |