LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Engine Controls - System & Component Testing - V6 & V8) >> Engine Sensors & Switches >> Airflow Meter >> All Models

All Models

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. Remove airflow meter. See AIRFLOW METER under ENGINE SENSORS & SWITCHES in REMOVAL & INSTALLATION - V6 & V8 article.
  2. Note identification of terminals E2 and THA on airflow meter. See Fig 1-Fig 4 . Using ohmmeter, check resistance between terminals E2 and THA on airflow meter. Resistance should be within specification in relation to the temperature. See AIRFLOW METER RESISTANCE  table. Replace airflow meter if resistance is not within specification.
  3. Airflow meter operation should be checked. On Avalon, Camry Solara, Land Cruiser, Sequoia, Sienna, Tacoma, Tundra, and 4Runner 4.7L, go to next step. On Camry, Highlander and 4Runner 4.0L, go to step  6.
  4. Install electrical connector on airflow meter. Connect voltmeter leads to proper terminals on airflow meter with electrical connector installed. See Fig 5-Fig 8 .
  5. Turn ignition on. Apply air into designated area on airflow meter and note voltage reading. While air is being applied, voltage reading should fluctuate. Replace airflow meter if voltage does not fluctuate. Turn ignition off. Remove voltmeter.
  6. Apply battery voltage to +B terminal on airflow meter and battery ground to E2G terminal on airflow meter. Connect voltmeter leads to proper terminals on airflow meter. Apply air into designated area on airflow meter and note voltage reading. See Fig 2. While air is being applied, voltage reading should fluctuate. Replace airflow meter if voltage does not fluctuate. Disconnect battery and remove voltmeter.
AIRFLOW METER RESISTANCE

Temperature Ohms
Avalon
-4°F (-20°C) 13,600-18,400
68°F (20°C) 2210-2690
140°F (60°C) 490-670
Camry
-4°F (-20°C) 13,600-18,400
68°F (20°C) 2210-2690
140°F (60°C) 493-667
Camry Solara
-4°F (-20°C) 14,600-17,800
68°F (20°C) 2210-2690
140°F (60°C) 290-350
Highlander
-4°F (-20°C) 13,600-18,400
68°F (20°C) 2210-2690
140°F (60°C) 493-667
Land Cruiser, Sequoia, Tundra 4.7L & 4Runner 4.7L
-4°F (-20°C) 12,500-16,900
68°F (20°C) 2190-2670
140°F (60°C) 500-680
Sienna & 4Runner 4.0L
-4°F (-20°C) 13,600-18,400
68°F (20°C) 2210-2690
140°F (60°C) 490-670
Tacoma & Tundra 3.4L
-4°F (-20°C) 13,600-18,400
68°F (20°C) 2200-2700
140°F (60°C) 500-700
Fig 1: Identifying Airflow Meter Terminals (Avalon, Sienna, Tacoma & Tundra 3.4L)
G99E08734Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 2: Identifying Airflow Meter Terminals, Air Application Area & Voltmeter Connections (Camry, Highlander & 4Runner 4.0L)
G00028714Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 3: Identifying Airflow Meter Terminals (Camry Solara)
G97D06881Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 4: Identifying Airflow Meter Terminals (Land Cruiser, Sequoia, Tundra 4.7L & 4Runner 4.7L)
G98F11507Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 5: Testing Airflow Meter Operation (Avalon & Sienna)
G00009724Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 6: Testing Airflow Meter Operation (Camry & Camry Solara)
G97F06882Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 7: Testing Airflow Meter Operation (Land Cruiser, Sequoia, Tundra 4.7L & 4Runner 4.7L)
G98G11508Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
Fig 8: Testing Airflow Meter Operation (Tacoma & Tundra 3.4L)
G99H08735Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002