LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 127 (Engine Controls - System & Component Testing - 4-Cylinder) >> Engine Sensors & Switches >> Air/Fuel Ratio Sensor >> Camry Solara

Camry Solara

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: For diagnostic steps that are not listed, see SELF DIAGNOSTICS - CAMRY SOLARA - 4-CYLINDER article.
  1. Heated A/F sensor is mounted on exhaust manifold above catalytic converter. If problem exists in A/F sensor, heater or wiring circuit, a Diagnostic Trouble Code (DTC) may be stored in Engine Control Module (ECM). See TESTING PROCEDURE under SELF-DIAGNOSTIC SYSTEM in appropriate SELF-DIAGNOSTICS article for retrieving of DTCs.
  2. To test heater resistance on A/F sensor, disconnect electrical connector for A/F sensor. Using ohmmeter, check resistance between +B and HT terminals on electrical connector. See Fig 1. Replace A/F sensor if resistance is not within specification. See A/F SENSOR HEATER RESISTANCE (CAMRY SOLARA)  table. See AIR/FUEL SENSOR under ENGINE SENSORS & SWITCHES in REMOVAL & INSTALLATION - 4-CYLINDER article.
A/F SENSOR HEATER RESISTANCE (CAMRY SOLARA)

Application & Temperature Ohms
68°F (20°C) .8-1.4
1472°F (800°C) 1.8-3.2
Fig 1: Testing Heater On Air/Fuel Sensor (Camry Solara)
G00025430Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002