LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 124 (Engine Control System Self Diagnostics - 4-Cylinder) >> Diagnostic Tests >> DTC P0340: Camshaft Position Sensor "A" Circuit (Bank 1) &/Or DTC P0341: Camshaft Position Sensor "A" Circuit Range/Performance (Bank 1) >> Possible Causes

Possible Causes

WARNING: This page is about a different car, the 2003 Toyota Tacoma. However, it is still accessible from the selected car via links, so may be relevant.

DTC is set when ECM does not receive input signal from camshaft position sensor. If DTC P0340 exists, ECM will operate in fail-safe mode. Possible causes are:

scientia non olet · About LEMON Manuals