DTC P0031, DTC P0032, DTC P0037, DTC P0038, DTC P0051, DTC P0052, DTC P0057 Or DTC P0058: Notes
WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.
Code Definition
- DTC P0031: Oxygen Sensor Heater Control Circuit (Bank 1 Sensor 1)
- DTC P0032: Oxygen Sensor Heater Control Circuit (Bank 1 Sensor 1)
- DTC P0037: Oxygen Sensor Heater Control Circuit (Bank 1 Sensor 2)
- DTC P0038: Oxygen Sensor Heater Control Circuit (Bank 1 Sensor 2)
- DTC P0051: Oxygen Sensor Heater Control Circuit (Bank 2 Sensor 1)
- DTC P0052: Oxygen Sensor Heater Control Circuit (Bank 2 Sensor 1)
- DTC P0057: Oxygen Sensor Heater Control Circuit Low (Bank 2 Sensor 2)
- DTC P0058: Oxygen Sensor Heater Control Circuit (Bank 2 Sensor 2)
CAUTION:
If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - TOYOTA
article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT.