LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 12 (Engine Controls - On-Vehicle Adjustments - 4-Cylinder) >> Ignition Timing >> CELICA & Echo

CELICA & Echo

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2002 Toyota Tacoma, 2002 Toyota RAV4, 2002 Toyota Prius, 2002 Toyota MR2, and 2002 Toyota Highlander. However, it is still accessible from the selected car via links, so may be relevant.
  1. Start engine and warm engine to normal operating temperature. Shut engine off. Connect timing light lead to cylinder No. 1. Cylinder No. 1 is front cylinder at timing chain end of engine.
  2. Apply parking brake. Place transaxle in Neutral. Note location of data link connector No. 3 at driver's side of instrument panel. See Figure and Figure . Install Jumper Wire (SST 09843-18020 or SST 09843-18040) between terminals No. 4 (CG) and 13 (TC) on data link connector No. 3. See Figure.
  3. Start engine. Check ignition timing with engine idling. Timing marks are located on timing chain cover, near crankshaft pulley. Ensure base timing is within specification at idle with transaxle in Neutral, and with A/C and all accessories off. See IGNITION TIMING SPECIFICATIONS  table. Shut engine off. Remove jumper wire and timing light.
scientia non olet · About LEMON Manuals