LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 112 (Engine Controls - Basic Diagnostic Procedures - 4-Cylinder) >> Ignition Systems >> Camshaft Position Sensor >> Camry, Camry Solara, ECHO & Highlander

Camry, Camry Solara, ECHO & Highlander

WARNING: This page does not describe the selected car, but rather 11 other vehicles, including the 2003 Toyota Tacoma, 2003 Toyota RAV4, 2003 Toyota Prius, 2003 Toyota Matrix, and 2003 Toyota MR2. However, it is still accessible from the selected car via links, so may be relevant.
  1. Camshaft position sensor may also be referred to Variable Valve Timing (VVT) sensor. Disconnect electrical connector at camshaft position sensor. Camshaft position sensor is located on end of cylinder head at flywheel end of engine, just at end of intake camshaft. See Figure and Figure . Using ohmmeter, check resistance between electrical terminals on camshaft position sensor.
  2. Ensure camshaft position sensor resistance is within specification. See CAMSHAFT POSITION SENSOR RESISTANCE  table. Replace camshaft position sensor if resistance is not within specification. See CAMSHAFT POSITION SENSOR under IGNITION SYSTEMS in REMOVAL & INSTALLATION - 4-CYLINDER article. Reinstall electrical connector on camshaft position sensor.
scientia non olet · About LEMON Manuals