Knock Sensor (Land Cruiser, Sequoia, Tacoma 3.4L V6, Tundra & 4Runner)
WARNING: This page does not describe the selected car, but rather 17 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota RAV4. However, it is still accessible from the selected car via links, so may be relevant.
Knock sensors No. 1 and 2 monitor ignition knock conditions and deliver input signals to KNK1 and KNK2 terminals of Engine Control Module (ECM). ECM may use input signal for determining ignition timing (spark advance) and for controlling fuel injection system. For knock sensor location, see KNOCK SENSOR under ENGINE SENSORS & SWITCHES in REMOVAL & INSTALLATION - V6 & V8 article.