Power Sun Roof REINITIALIZATION Procedure: 4Runner

WARNING: This page does not describe the selected car, but rather 10 other vehicles, including the 2003 Toyota Tundra, 2003 Toyota Tacoma, 2003 Toyota Sienna, 2003 Toyota Sequoia, and 2003 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If the battery terminal is disconnected or after the jam protection function has operated, the ECU of the sliding roof motor may not detect the position of the roof glass. If the AUTO operation function is still disabled even if the sliding roof motor is reset, the hall IC (built in the sliding roof motor assy) for detecting the roof glass position may malfunction.

If the AUTO operation function does not operate, reset the sliding roof motor using either of the following ways:

Press the sliding roof switch on TILT UP side and hold it. When the roof glass stops at the fully tilted-up position, the reset of the motor is completed.
Fully open the roof glass, press the sliding roof switch on SLIDE OPEN side and hold it for ten seconds. Ten seconds later, the reset of the motor is completed.