LEMON Manuals: Even more car manuals for everyone
Home >> Toyota >> 2001 >> Sienna CE >> Repair and Diagnosis >> External Pages >> Different car >> Section 100 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P2111: Throttle Actuator Control System Stuck Open Or DTC P2112: Throttle Actuator Control System Stuck Closed >> Diagnosis & Repair

Diagnosis & Repair

WARNING: This page is about a different car, the 2003 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check whether or not a foreign body is caught between the throttle valve and housing. Repair as necessary. If okay, go to next step.
  2. Disconnect the throttle control motor connector. Measure the resistance between the terminals of throttle control motor terminals No. 1 and 2. See Figure. Resistance should be .3-100 ohms at 68°F (20°C). If resistance is to specification, go to next step. If resistance is not to specification, replace throttle body assembly.
  3. Disconnect the T2 throttle control motor 2-pin connector. See Figure. Disconnect the ECM E2 connector. Check the continuity between the wire harness side connectors. See Figure. See THROTTLE CONTROL MOTOR/ECM CONTINUITY CHECK  table. If continuity is to specification, problem is intermittent. If continuity is not to specification, repair or replace harness and connector as necessary.
scientia non olet · About LEMON Manuals