DTC P0120, DTC P0122, DTC P0123, DTC P0220, DTC P0222, DTC P0223 Or DTC P2135: Notes
WARNING: This page is about a different car, the 2003 Lexus SC 430. However, it is still accessible from the selected car via links, so may be relevant.
Code Definitions
- DTC P0120: Throttle/Pedal Position Sensor/Switch "A" Circuit
- DTC P0122: Throttle/Pedal Position Sensor/Switch "A" Circuit Low Input
- DTC P0123: Throttle/Pedal Position Sensor/Switch "A" Circuit High Input
- DTC P0220: Throttle/Pedal Position Sensor/Switch "B" Circuit
- DTC P0222: Throttle/Pedal Position Sensor/Switch "B" Circuit Low Input
- DTC P0223: Throttle/Pedal Position Sensor/Switch "B" Circuit High Input
- DTC P2135: Throttle/Pedal Position Sensor/Switch "A"/"B" Circuit
NOTE:
For information on engine immobilizer system, see COMPUTERIZED ENGINE CONTROLS
in THEORY & OPERATION article.
CAUTION:
If ECM replacement is instructed in following testing, always ensure ECM harness connector and ground circuit are okay. If either are suspect, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - LEXUS
article.